At least in one game R1 didn't work as expected. I found this necessary because the pre-configured bindings were misconfigured, I believe. Right-click on the list on the left and choose "Clear All".Select Allow All Devices in the select box near the bottom.Remove all pre-configured and superfluous bindings: Open the LilyPad Settings dialog from before.
#Lilypad pcsx2 set up drivers
Try restarting your PC after having installed the software and drivers above.įinally, configure the bindings for the controller: ️ You don't see the controller listed in the device list?.If you randomly press buttons or move analog sticks on the controller, you are supposed to see some changes there. You will be presented a dialog with numeric values. Choose Test Device as shown in the screenshot.For XInput it's called XInput Pad 0, for Direct Input it's called DX Controller (XBOX 360 For Windows). Now right-click in the device list under Device Diagnostics on your device.Choose one of those APIs, preferably DirectInput, and make sure it's activated in the Game Device APIs section.Both of them are listed under Game Device APIs. You can use your controller either with the DirectInput or XInput API. You should get the following "LilyPad Settings" dialog: Go to Config -> Controllers (PAD) -> Plugin Settings: If you configured it as a service, just carry on. If you ran in the step before, you should now see Device is DualShock3 with address. If you even configured it as a Windows service as the Shibari installation guide describes, then you don't have to do anything.Ĭonnect your DualShock controller via USB to your PC Start Shibari if you just downloaded and extracted Shibari above, then run the extracted file.
#Lilypad pcsx2 set up install
Install Shibari by following the Shibari installation guide.Install ViGEmBus by downloading and running the setup of the latest ViGEmBus release.Extract that to some arbitrary location and then run the exe file.